![]() |
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 | ||
Regular Member
Join Date: Aug 2010
Location: hallam
Posts: 231
|
Hey guys i recently converted my series 3 au wagon to manual, been towing a trailer lately for work, on the drive home from lakes entrance to narre warren i noticed a nocking noise sounds like a rattle gun, only does it in 1st 2nd 3rd only when i let go of the accelerator under acceleration its fine. any help to solve the problem would be greatly appreciated! Thanks in advance!
|
||
![]() |
![]() ![]() |
![]() |
#2 | ||
When in doubt, GAS IT!!
Join Date: Sep 2006
Location: Lower Eyre Peninsula, SA
Posts: 3,018
|
Many moons ago I had what sounds like similar symptoms in a HQ 4spd. In that case it turned out to be the front counter shaft bearing dying. It only did it in the lower gears because as you go up through the gears and swap cogs the load shifts back along the shaft to the rear where the bearing is still ok hence there is now no pressure on the front bearing so the noise goes away. Lean on the shifter when you move off and if there's a problem in the box you should feel it transmitted up through the shifter. If it is the front bearing I'd be pulling the box out asap before the bearing collapses completely and locks up the box. If you must drive it like that I'd strongly suggest light throttle, low revs and short shift till you get into 4th to lessen the chance of leaving bits of gearbox all over the road.
Cheers Bushbasher
__________________
. HERS- BFIII Wagon Gold, alloys, dual fuel, bullbar, big tow pack, trans cooler, fully rebuilt HD suspension, Clarion, alarmed, full 2 1/2" sports system, mint body MINE- AUII Forte Meteorite, dual fuel but otherwise bog stock. MINE- AUII Fairlane Sportsman Liquid Silver over meteorite,HIDs', Airhog, Eagle Leads, dual fuel, custom rear springs, BA slotted discs + a second one for spares . |
||
![]() |
![]() ![]() |
![]() |
#3 | ||
Regular Member
Join Date: Aug 2010
Location: hallam
Posts: 231
|
hmmm well that sucks, need my car for everyday use, dont exactly want it locking up with my 10 month old daughter in the car either! how much would a bearing kit roughly be?
|
||
![]() |
![]() ![]() |
![]() |
#4 | ||
Regular Member
Join Date: Aug 2010
Location: hallam
Posts: 231
|
Just got a price on an overhaul kit and a basic kit
$375 for overhaul $195 for basic, basic comes with gaskets some bearing and seals. How hard is it to do a rebuild on one of these? are the bearings pressed in? Im waiting on a phone call back to see if its covered by warranty so ill go from there. |
||
![]() |
![]() ![]() |