UK- to remove the wires you need to move the inside white part of the plug, it will slide across if you push the sides out slightly holding in place
then like fourl6 said a very small flat screw driver or i got some thin gauge wire myself and on the wire where its clipped in you will see a small gap shove the screw driver or wire in there as far as you can and it should release the clip holding it in, then just pull on the wire and it should pop out
and as advised get some tape or heat shrink and cover up the 4 wires you are moving to stop them shorting out on the other pins or go to the wreckers and get a plug from a high series which is what i did and makes it alot easier if you intend on stuffing around with the cluster more in the future
cheers mate hope it all goes well
|