Quote:
Originally Posted by oldel
No glue or sealer will stop mains water pressure.
If you had an oxy torch then replacing the section of pipe is easy. Sweat the pipe out of the old solder join, solder in a tiny bit of copper - cheap as - if you had the copper and oxy...
If you do not, then cut the copper away from the solder elbow join, play mechano with compression fittings and an end cap or valve.
Nothing else is going to fix it, don't waste your time with glues, tape and sealants.
|
So "Stop Gap" products useless......
If I knew what an Oxy Torch was I'd use it. Mate I'm completely useless and extremely ****ed off this has happened.
Thank you.
Just shows how stupid I am I guess.