Then I attached the engine lift to the lifting plate & started lifting until the engine just raised up on the mounts by a fraction to take the weight off the bolts to make it easy to slide them out
Then you just start jacking up, puling forward & tilting the whole assembly back (having a load leveler on the engine hoist makes this a one man job)
Keep repeating the whole up, forward, tilt thing until the whole lot is clear of the car
Job done
With that done I put the old girl back up on axle stands (guess who needs a 2nd hoist) so she was at a nice working height & I cut the back off again… what is it with me & plasma cutters & angle grinders, anyway I have a new boot floor to go in, so for easy access I removed the light panel again & the fuel tank